Select Page

SMR Gearbox Set up
Satisfactory functionality is determined by right set up. lubrication and upkeep. thus it is crucial the directions within the installation and upkeep leaflet. provided with every gearbox. are followed very carefully. some of the crucial aspects of belt and torque-arm installation are listed under.
one. Install pulley on gearbox input shaft as near for the reducer doable, and mount reducer on driven shaft as shut to bearing as practical. failure to perform this will cause excess loads within the input shaft bearings and output bearings and could result in their premature failure.
two. Install motor and wedge belt drive with the belt pull at approximately 90° towards the center line among driven and input shafts. this may allow tensioning from the wedge belt drive with all the torque arm which should really preferably be in tension. if output hub runs anti-clockwise. torque arm should be positioned the best.
three. lnstall torque-arm fulcrum on the rigid help to ensure the torque-arm is going to be at around appropriate angles to the center line through the driven shaft as well as the torque arm situation bolt. ensure that there may be enough take up inside the turnbuckle for belt tension adjustment.
Keep near.
Bell drive can be located in any practical postion. if your torque arm is to be utilized to tighten the belts, the drive must be at about tight angle to your line amongst the input and output shafts.
Bell drive could be found towards the correct if sought after.
If output hub rotates clock-wise. position belt drive and torque arm in opposite course to that proven while in the illustration.
Torque arm and belt take up.
Torque arm could possibly be mounted to your suitable if desired.