Select Page

1.A connecting link of an O-ring Chain for standard application is pre-coated with grease on the pins. Ahead of connection, confirm the grease about the surfaces of pins, and if your volume of grease is small, apply grease with bare hands. (If gloves are utilised, the grease might be absorbed from the gloves.)
Example: Once the connecting link (I) of an O-ring chain for general application is
shipped, O-rings are fitted with the roots in the pins. If your O-rings come loose as a result of vibration for the duration of transport, refit the O-rings in to the roots on the pins.
In this instance, be sure you return the grease collected at the roots of your pins towards the central surfaces with the pins, much more at portion A than at portions B shown in the above illustration. (Portions A is worn on account of sliding together with the bushings.)
2.The chain can be most effortlessly linked about the teeth of a sprocket. Engage the links at the two ends from the chain using the sprocket teeth and fit connecting pins. When the sprocket is usually moved, the chain can also be connected on the loosened side.
3. Connecting process
one.Verify that O-rings are attached on the roots on the pins.
two.If the amount of grease utilized within the connecting pins is smaller, coat the pins with grease on the central portions.
3.Insert the connecting pins to the bushings of your inner hyperlinks at the two ends.
four.Confirm that the grease is utilized to the complete encounter of the O-ring, and fit the O-ring onto the connecting pins.
five.Insert the connecting pins into the connecting plate and although pressing the connecting plate, install the spring clip. Verify irrespective of whether the head (the end with no split) of the spring clip is turned during the feeding path of the chain. (See the following illustration.)
6.Make sure to confirm that the spring clip is securely fitted while in the clip grooves of your connecting pins.
This completes jointing from the connecting hyperlink. Note that grease within the surfaces of connecting pins and O-rings might be removed all through installation operate. In this case, re-grease utilizing the grease about the surface with the base chain or even the grease within the polyethylene bag in which the connecting link was contained.