Electrical power UNITS FOR LIFT TABLE

Energy UNITS FOR LIFT TABLE one
Basic Description
This power unit is designed solely to the smaller lift table,Consisting of high strain gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit continues to be extensively applied during the marketplace of logistic gadgets like minifork lift, scissors lift and ariel operating platforms. The lower-ing movement is controlled by the solenoid valve together with the speed managed by the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
General Description
This power unit is designed solely for the medium lift table, Consisting of remarkably effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve along with the pace controlled from the adjustable needle valve. Once the lift rises to a higher positoin, but the power provide is reduce, the decreasing movement is controlled through the manual override perform.
Power UNITS FOR LIFT TABLE three
Common Description
This power unit is developed solely for your significant lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve and the speed controlled by a strain compensated movement control valve.
Power UNITS FOR LIFT TABLE 4
Basic Description
This electrical power unit is created solely for the significant lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve along with the pace controlled by the adjustable needle valve. When the lift rises to a substantial positoin, but the power supply is reduce, the reducing motion is controlled through the manual override function.
Exclusive Notes
1. This energy unit is of S3 duty cycle, which could only perform intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean the many hydraulic elements concerned ahead of installation of the power unit.
three. Viscosity of the oil shoud be 15~46 cst,which should also be clean and cost-free of impurities.N46 hydraulic oil is suggested.
four. Oil altering is required just after the preliminary one hundred operation hours,afterwards the moment every single 3000 hours.
five. The power unit proven is built to be mounted vertically.